Die leichte, handliche Führungsschiene für Gelegenheitsholzfäller, die kleine elektrische und benzinbetriebene Kettensägen verwenden. Spannen Sie Ihre Kette mit der Intenz-Selbstspannfunktion direkt auf der Säge.
Produktdetails
Teilung: 3/8" Low Profile™, Schnittfuge: .050" - 1.3 mm, Anzahl der Treibglieder: 62
Der Intenz®-Spannmechanismus ist in der Führungsschiene selbst eingebaut
Umkehrbar für längere Lebensdauer
Teilung: 3/8" Low Profile™, Schnittfuge: .050" - 1.3 mm, Anzahl Glieder des Kettentriebs: 56
Kettensägen, die ursprünglich mit einer Intenz®-Schiene ausgestattet waren, haben keinen „Einstellstift“ zum Spannen der Kette. Verwenden Sie eine Intenz®-Schiene NUR DANN, wenn Sie die Führungsschiene an diesen Sägen austauschen
WARNING: This product can expose you to chemicals including Nickel, which is known to the State of California to cause cancer. For more information go to www.P65Warnings.ca.gov
Spezifikationen, Details und Unterstützung
Guide Bar
Product Family
Single Rivet
Pitch
Pitch
Chain Pitch is the size of the chain, and is defined as the distance between any three consecutive rivets divided by two. Oregon chain is made in several pitches - 1/4" is the smallest, 3/8" is the most popular, 3/4” is the largest. Pitch is important because the drive sprocket must be the same pitch as the chain, and if applicable, the bar nose sprocket. The easiest way to determine the pitch of your chain is to look at the number stamped on the drive link.
3/8" Low Profile™
Gauge
Gauge
Chain Gauge is the Drive Link's thickness where it fits into the bar groove. The gauge of the chain and the gauge of the bar must match. Oregon has several gauges for chainsaws - such as, .043", .050", .058" and .063". Normal wear can make it difficult to accurately measure chain gauge on a worn chain. Always order by the number stamped on the drive link of your old chain to assure correct gauge.
.050"
Drive Links
Drive Links
The length of your chain is determined by counting the number of drive links in your chain. Your drive link count has a direct correlation to your bar’s length. Be careful; a bar made by Oregon may take a different drive link count than that of another producer. Here’s a tip: count the number of drive links in the chain you have now, and write that number down someplace where you can find it. Or, if you have an Oregon chain in an Oregon box, the drive link count is stamped on the flap; you can save that flap for future reference.
56.0
Bar Length
16"
Tail Mount
T041
Guide Bar Code
SDE
Guard Mate Compatible
Guard Mate Compatible
Guard Mate holes are built into the noses of certain types of Oregon guide bars and allow the attachment of a Guard Mate tip guard to help reduce the risk of kickback.
Nein
Intenz
Intenz
Intenz guide bars have our patented Intenz chain tensioning mechanism built right into the bar itself. Replace a Intenz guide bar with another Intenz guide bar to maintain the saw’s ability to properly tension the saw chain.
Ja
Narrow Kerf
Narrow Kerf
Thickness of side laminates is reduced to obtain all the advantages of narrow kerf cutting when used in combination with all narrow kerf .325" 95-series chain.
