Oregon 90cm Harvester Bar, SpeedMax XL .404

This product is only available through retailers or servicing dealers.

Quick Links:

Specifications, Details & Support Reviews

Unrivalled. Distinctive. Rugged. Minimize the time between cuts and reduce vibration for your entire cutting system. The Oregon SpeedMax XL replacement nose (RSN) guide bar features a wider and stronger body achieved with Chrome-Moly Plating. Designed with vibration reduction and a re-engineered tail contour that is less likely to throw chains. The patented Jet-Fit bar-mount system maximizes productivity. The slotted motor-mount design fits harvester equipment outfitted with automatic chain tensioners and easily slides in and out of the bar clamp. The Jet-Fit is available in .080" gauge.

Product Details

The patented Jet-Fit bar-mount system maximizes productivity. The slotted motor-mount design fits harvester equipment outfitted with automatic chain tensioners and easily slides in and out of the bar clamp
Guide bar RSN requires fewer rotations ultimately extending the life of your bar
The RSN is equipped with a larger, 14-tooth sprocket featuring high-alloy industrial bearings leading to reduced heat build-up and longer-lasting parts
With a 28% increase in length, the new RSN absorbs most rail wear
Guide bar RSN can be replaced in the field several times, decreasing downtime between cuts
Re-engineered tail contour decreases friction lowering the likelihood of throw chain and improving your valuable time in the cab
Designed with a wider bar body and chrome-moly plating for reduced deflection
Guide bar lubrication dam increases contact between chain drive links and oil, significantly reducing oil waste
Image shown may not reflect actual bar tail motor mount, check Oregon Harvester Catalog for actual tail mount configurations

Specifications, Details & Support

Harvester Guide Bars
Product Family	SpeedMax XL
Guide Bar Code	SMR
Bar Length	90.0 cm
Pitch Pitch Chain Pitch is the size of the chain, and is defined as the distance between any three consecutive rivets divided by two. Oregon chain is made in several pitches - 1/4" is the smallest, 3/8" is the most popular, 3/4” is the largest. Pitch is important because the drive sprocket must be the same pitch as the chain, and if applicable, the bar nose sprocket. The easiest way to determine the pitch of your chain is to look at the number stamped on the drive link.	.404"
Gauge Gauge Chain Gauge is the Drive Link's thickness where it fits into the bar groove. The gauge of the chain and the gauge of the bar must match. Oregon has several gauges for chainsaws - such as, .043”, .050"", .058” and .063"". Normal wear can make it difficult to accurately measure chain gauge on a worn chain. Always order by the number stamped on the drive link of your old chain to assure correct gauge.	.080"
Drive Links Drive Links The length of your chain is determined by counting the number of drive links in your chain. Your drive link count has a direct correlation to your bar’s length. Be careful; a bar made by Oregon may take a different drive link count than that of another producer. Here’s a tip: count the number of drive links in the chain you have now, and write that number down someplace where you can find it. Or, if you have an Oregon chain in an Oregon box, the drive link count is stamped on the flap; you can save that flap for future reference.	106.0
Tail Mount	U249

General
Quantity	1 Pack